This red car bow is perfect for placement on hoods, windshields, or any other flat surface. This pull bow is shipped in a ribbon roll and takes approximately one minute to automatically assemble itself into shape. Just pull the two inner ribbon strings and the bow will form itself before your eyes! Perfect shape guaranteed! Easy to follow instructions included. Decorate cars, extra large gifts, in-store merchandise, grand openings, parties, theme events and more.
1. Remove and unroll the ribbon, keeping the small ribbon inside the large ones Unroll carefully keep everything together, if something is out of place put it back before proceeding and do not remove any part of the ribbon assembly.
2. Find the 2 inner ribbons at the end and pull them with one hand while pushing the larger ribbons away with other hand.
3. As the bow starts to form, pay attention to the plastic plates and be sure they stay in place, do not remove them at any point.
4. When it is completely formed, tie a bow with the small ribbons to keep it together. This will allow you to reuse the bow later.
5. Attach the suction cup with the adhesive.
6. Do not cut off the strings off if you want to use the bows again and do not remove any of the strings or plastic plates since they hold the bows together.
Made with 6″ wide high gloss thick poly ribbon
23″ diameter is measured between ends of loops
With included 28″ tails spread apart horizontally, total width becomes 56″. the box size is 17*11*11 cm
Ships flat and rolled and forms in seconds by pulling two inner ribbon strings
Attaches easily to car surface with included suction cup